Currier Tech 650CD Series Informations techniques télécharger pdf (Page 10)

18 19

www.CurrieTech.com

OM Chain Drive Scooters - 2012.indd

Modied 05/25/2012

Currie Technologies

The line voltage will fluctuate depending on the instantaneous load that the

motor is under. For example, when starting out from a dead stop, or going

up a steep hill, the motor will be under a high load and the “Yellow” or even

“Red” LED will illuminate. To a lesser degree, another factor that influences

the load on the motor (and therefore the LED readings) is the gearing of the

motor. Scooters with Direct Drive (DD) gearboxes are geared for slightly

higher top end speeds and therefore have a higher load when starting from

a dead stop versus scooters with belt or chain drive, which have a lower top

end speed. The higher gear ration of the DD scooters will cause the Red LED

to illuminate more often compared to other scooters.

When the throttle is disengaged (i.e. no power to the motor due to the

scooter being stationary or coasting) the LED’s on the throttle will indicate

the voltage of the battery pack. The voltage of the battery pack will rise

when no load is on the motor. The best indication of how much battery life is

remaining is to check the throttle LED’s, after reaching cruising speed, on a

flat straight road as this will allow the battery voltage to stabilize and give a

much more accurate reading.

5 MINUTE SLEEP MODE

Scooters are equipped with a 5 minute sleep mode. If no activity is detected

after 5 minutes the scooter will go into stasis mode to conserve the batteries.

To restart, cycle the power switch Off then On.

Never store your scooter in Sleep Mode as battery power

will still be used by the scooter. Always be sure to turn the

power switch to the “OFF” position.

HEAT SHUT-DOWN MODE

If the controller has over-heated and power to the motor has been shut down,

turn the main power switch “OFF” for at least 30 minutes to allow the controller

to cool down before riding any more. Turn the power switch “ON” and resume

riding.

The scooter will shut down due to over-heating caused

by excessive stress on the motor (i.e. too steep a hill, too

heavy a rider, etc.).

WARNING

THROTTLE AND BRAKE OPERATION & ADJUSTMENT

THROTTLE OPERATION

The speed of the Electro-Drive™

scooter is controlled by a grip-

twist throttle, which is located on

the handlebar.

To check the throttle operation,

turn the power switch to the

“OFF” position. Fully twist the

throttle then quickly release it.

The throttle is spring loaded and

should immediately spring back to

its original (also know as “Zero Position) position.

To accelerate, twist the right hand throttle grip towards you as you stand

on the deck plate. The more you twist the throttle, the faster the motor will

propel the scooter until you reach the scooter’s top speed.

To go slower, or coast to a slower speed, allow the throttle to spring back to

its original position. To decelerate or come to a complete stop, release the

throttle and allow it to return automatically to its original position. Then squeeze

the brake lever(s) to activate the brake(s). Remember to release the throttle

whenever you apply the brake.

The throttle and its components are fully assembled and

tested at the factory. Do not attempt to adjust them at

any time. If you feel the throttle and/or components are in

need of service DO NOT RIDE THE SCOOTER! Con-

tact Currie Technologies

Customer Service number at

1-800-377-4532.

If you do not fully understand how to operate your scooter

throttle properly, DO NOT RIDE YOUR SCOOTER. Con-

tact Currie Technologies Customer Service for information

and instructions at 1-800-377-4532.

HOW TO USE THE THROTTLE LED’S

When the throttle is engaged (powering the motor) and the scooter is in mo-

tion, the LED’s on the throttle indicate instantaneous line voltage as mea-

sured at the battery terminals -- and not the available energy in the battery

pack.

WARNING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Currier Tech 650CD Series Informations techniques Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Scooters Currier Tech 650CD Series